Checking The Installation - Husqvarna 305 Operator's Manual

305_308,EN.book Page 34 Saturday, November 8, 2014 12:33 PM
6. Connect the guide wire to the boundary wire
using a coupler:
Insert the boundary wire in each of the holes in
the coupler. Insert the guide wire in the centre
hole in the coupler. Check that the wires are fully
inserted into the coupler so that the ends are
visible through the transparent area on the other
side of the coupler.
Use a polygrip to completely press down the
button on the coupler.
It does not matter which holes are used to
connect each wire.
7. Staple down/bury the connector in the lawn.
IMPORTANT INFORMATION
The function of the guide wire varies
depending on the layout of the working area.
This is why it is recommended to test the
installation using this function See
6.4 Installation on page 48.
.
IMPORTANT INFORMATION
The guide wire may not cross the boundary
wire, for instance a boundary wire that is laid
out to an island.

3.7 Checking the installation

Check the loop signal by inspecting the indicator
lamp on the charging station.
See 9.2 Indicator lamp in the charging station on
page 69 if the lamp does not indicate a solid green
light.
34 - English
3. INSTALLATION
3012-954
3018-055
3018-073
3012-998