Aerials; Operating Instructions - Cambridge Audio Topaz SR20 User Manual

Aerials

Note: The SR20 is supplied with a temporary aerial for initial use. For
permanent use, outdoor aerials are highly recommended.
AM loop aerial
Connect each end of the single length antenna to the antenna terminals.
Place the antenna as far from the main system as possible to prevent
unwanted noise and to obtain optimum reception. If the AM loop aerial
provided does not provide sufficient reception, it may be necessary to use
an outdoor AM aerial.
FM aerial
Connect the supplied aerial to the FM 75 ohm socket. Extend and move
the aerial lead around until you get the best reception. For continued use,
we strongly recommend using a 75 ohm outdoor FM aerial.
10

Operating instructions

After making any connections to your unit, activate the Topaz SR20 by
pressing the On/Off button on the front of the unit.
Setting the source
Press the Source button on the front of the unit corresponding to your
desired source. Alternatively, you may use the appropriate button on the
remote control.
PHONO
Adjusting the volume
Use either the Volume Up/Down buttons on the remote control, or the
Volume control on the front of your unit system to change the volume
level. The newly selected level will be indicated briefly on the front
display.
The volume is displayed in minus dB where 0dB is the highest level.
A progressively larger negative number indicates the volume is being
reduced.
VOLUME -40dB
Adjusting the audio settings
Adjustments to the bass, treble and balance can be made as follows:
1. To enter the audio menu. Press either the Menu button on the front of
the unit or on the remote control.
BASS
2. Step through the available settings by pressing the Menu button. The
settings available are in order Bass, Treble and Balance.
3. When you wish to make an adjustment for bass, treble or balance,
simply rotate the Volume control or use the Volume control buttons
on the remote control.
BASS
4. To exit, wait for five seconds, until the unit returns to normal mode.
Tuning and listening to the built in tuner
Select the Tuner source using the FM/AM button on the front of the unit,
or directly by pressing the FM or AM buttons on the remote.
FM 87.50MHz
Repeatedly pressing the FM/AM button on the front of the unit switches
between FM and AM modes.
Note: For ease of tuning on first time use, we recommend that you set
the Topaz SR20 to 'Auto' mode. Press the Mode/Store button on the
front of the unit. This button cycles through Preset, Auto and Manual,
modes.
0dB
+ 4dB