Door Trim; Grate Installation; Log Placement - Napoleon BGD36CFGN Installation And Operating Instructions Manual

30

DOOR TRIM

The BGD42CF comes
complete with top door
trim
(W715-0729).
1. Guide the arms of the
trim into the slots that
are slightly hidden under
the facing through the
opening between the top
of the door and the bot-
tom edge of the facing
as illustrated in the front
view.
2. Slide the arm into the
slot far enough to allow the
front edge of the trim to go
in behind the facing.
3. Let the bracket come
forward towards the back
of the facing and allow the
trim to rest on the inside
lip, this position will allow
the notch on the arm of the
trim to fall into place
on the edge of the
slot.
FIGURE 102c

GRATE INSTALLATION

The grate for this fi replace has been removed for shipping pur-
poses.
The grate must be installed before the logs are installed.
Remove the packaging from the grate and install onto the two pins
as illustrated.
GRATE
FIGURE 103
W415-0661 / 12.07.07
NorthlineExpress.com
SLOT
FIGURE 102a
FACING
DOOR
BGD42CF FRONT VIEW
FIGURE 102b
NOTCH
INSIDE LIP
BGD42CF SIDE VIEW
BGD42CF WITH TOP DOOR TRIM INSTALLED
http://www.northlineexpress.com

LOG PLACEMENT

TM
PHAZER logs and glowing embers, exclusive to Napoleon®
Fireplaces, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the
TRIM glowing embers for a maximum glowing effect. Log colours may
vary. During the initial use of the fi replace, the colours will become
more uniform as colour pigments burn in during the heat activated
curing process.
FIGURE 104 FIGURE 104
1. Place the cutout in the bottom of log #1 behind the pilot assembly.
Rest the log against the back wall of the fi rebox.
FIGURE 105 FIGURE 105
2. Move the two small logs (#2 & #3) into position, lining up the studs
located on the burner with the holes on the bottom of the logs.
3. Tear the glowing embers into pieces and place along the front
row of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers into thin,
small irregular pieces as only the exposed edges of the fi bre hairs
will glow. The ember material will only glow when exposed to direct
fl ame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition. PHAZERtm logs glow when exposed
to direct fl ame.
FIGURE 106 FIGURE 106
4. Place the bottom of the left crossover log (#4) onto the stud on
the left side of the log support. The top of the log should rest in the
pocket on the back log.
FIGURE 107 FIGURE 107
5. Place the bottom of the right crossover log (#5) onto the stud on
the right side of the log support. The top of the log should rest in
the pocket on the left crossover log (#4).
Toll-Free 1-866-667-8454