Installation - Intermec EasyCoder 501 Service Manual

13.2 Installation

Screws
Bracket
Intermec EasyCoder 501 – Service Manual Ed. 7
The Memory Card Adapter Kit consists of the following parts:
• One Memory Card Circuit Board
• One Bracket
• One Connection Cable
• One Bus Driver Board
• One Address Decoder GAL 20V8 (fi tted on the circuit board)
• Three Screws RTK ST 3.5 x 9.5 FZB
• Two Screws RTK ST 2.9 x 16 FZB
• One installation instructions booklet
• Switch off the power. For double security, pull the power cord
out of the power cord receptacle at the rear plate of the printer.
• Open the right-hand door and remove the left-hand cover.
• Open the front hatch (or cutter unit).
• Using the three short #T10 Torx screws in the kit, attach the
bracket onto the adapter's circuit board. Also fi t the long end
of the connection cable to the connector at the rear part of the
adapter unit.
GAL Circuit
Circuit Board
Chapter 13 Memory Card Adapter
Bus Driver Board
Cable
109