Toyota Corolla 2016 Owner's Manual page 110

108
3-2. Opening, closing and locking the doors
■
Switching the door unlock function (vehicles with a smart key system)
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the engine switch off.
1
When the indicator light on the key surface is not on, press and hold
2
or
.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step
Multi-information
display
(if equipped)
Vehicles with an alarm: To prevent unintended triggering of the alarm, unlock
the doors using the wireless remote control and open and close a door once
after the settings have been changed. (If a door is not opened within 60 sec-
onds after
automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (→P. 68)
for approximately 5 seconds while pressing and holding
.)
2
Unlocking function
Holding the driver's door
handle unlocks only the
driver's door.
Holding the front passen-
ger's door handle unlocks
all the doors.
Holding either front door
handle unlocks
doors.
is pressed, the doors will be locked again and the alarm will
I n f o r ma t i o n P r o v i d e d b y :
Exterior: Beeps 3
times
Interior: Pings once
Exterior:
all the twice
Interior: Pings once
,
Beep
Beeps