Kenwood LZ-651W Service Manual page 7

The key ( "↑", "↓" ) of remote control is pushed and an adjust-
ment value is changed the whole STEP.
When "↑" is pushed once by remote control
The "ENTER" key of remote control is pushed, setting value is
decided, and it writes in EEPROM.
Push on the "DIRECT" key cancels for adjustment value, with-
out writing in EEPROM (Contrast returns to 80H).
The completion display of item adjustment
The "DIRECT" key is pushed and it exits from the setup mode.
4-3 OSD UN-displaying
It will be UN-displaying if the "MENU" key is pushed during
adjustment of each item in adjustment mode.
FULL NTSC
TEST MODE
Contras 80H
4-4 Change in the wide mode for display
During adjustment of each item in adjustment mode, push on
the MODE key changes the wide mode for display.
5 Change of screen control steps
The function makes easy to perform the test of the screen
control at the time of shipment inspection of operation. MIN
↔ CENTER ↔ MAX of each item is movable by one opera-
tion of remote control.
6 E2PROM clearance 1
condition for setup and screen control)
6-1 Operation
It pushes with "→" e "→" e "→" in displayed NAVI screen or
AV-IN screen in test mode.
Screen display
E2PROM
Are You
A setup at the time of factory shipments is written in by "EN-
TER" key, and "Complete" is displayed.
If it pushes except the "ENTER" key when exit without writing
in and "Cancel" will be displayed.
6-2 Contents of initialization:
Video source
Wide - mode
SP source
VOLUME
POWER
SCREEN CONTROL
• BRIGHT
• DIMMER
• TINT, COLOR, CONTRAST, BLACK : CENTER
SYSTEM CONTROL
• NAVI
• AV-IN
• BEEP
Cautions : Video parameter does not rewrite.
LZ-651W
(initialized of factory-shipments
CLEAR
Sure?
: RGB
: FULL
: NORMAL
: 21
: OFF
: MAX
: OFF
: RGB
: VD
: OFF
7