Wireless Resource Control - D-Link DAP-2230 User Manual

Section 3 - Configuration
The Wireless Resource Control window is used to configure the wireless connection settings so that devices can detect and
connect to the Access Point with the strongest signal.
Select 2.4 Ghz.
Wireless band:
Select Enable or Disable. This is an option for load balancing. This de-
Connection
Limit: termines whether to limit the number of users accessing this device. The
exact number is entered in the User Limit field below. This feature allows
the user to share the wireless network traffic and the client using multiple
APs. If this function is enabled and when the number of users exceeds this
value, or the network utilization of this AP exceeds the percentage that
has been specified, the DAP-2230 will not allow clients to associate with
the AP.
User Limit: Set the maximum amount of users that are allowed access (zero to 64 us-
ers) to the device using the specified wireless band. The default setting is
20.
11n Use the drop-down menu to Enable the 11n Preferred function. The wire-
Preferred:
less clients with 802.11n protocol will have higher priority to connect to
the device.
Network
Set the maximum utilization of this access point. The DAP-2230 will not
Utilization:
allow any new clients to associate with the AP if the utilization exceeds
the specified value. Select a utilization percentage between 100%, 80%,
60%, 40%, 20%, or 0%. When this network utilization threshold is reached,
the device will pause for one minute to allow network congestion to dis-
sipate.
Aging out:
Use the drop-down menu to select the criteria of disconnecting the wire-
less clients. Available options are RSSI and Data Rate.
D-Link DAP-2230 User Manual

Wireless Resource Control

32