Removing The Source Unit - Clarion FZ003A Owner's Manual & Installation Manual

Notes of installation
1. Before installation, please make sure
proper connections are conducted and
the unit operates normally. Improper
connection may result in damage to the
unit.
2. Use only accessories designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
3. Before installation, please fasten all power
cables.
4. Install the unit horizontally. Installing the
unit more than 30 degree vertically may
result in worse performance.
5. To prevent electric spark, connect the
positive pole first and then the negative
pole.
6. DO NOT block the cooling fan exit to
ensure sufficient heating dissipation of this
unit, or it may result in damage to this unit.
Stoppers
Screwdriver
Trim ring
FZ003A
10
Unit installation
Method A
1. Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting
tab outwards with a screwdriver to fix the
mounting bracket in place.
2. Slide the unit into the bracket until you hear
a click sound.
Instrument panel
Hole
Screw (M4x5)
Mounting bracket
Stoppers
Note:
Before attaching the mounting bracket, slightly bend the
spring toward the inside with your fingers and attach it to
the side of car.
Method B
Mounting Frame
1. Insert this unit directly to the opening of
the dashboard.
2. Place M5×6 cylindrical screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.
Trim ring installation
Strap
Attach the trim ring around the front panel.
Spring

6) Removing the Source Unit

Disassemble trim ring
1. Push the trim ring to right and pull out the
right part.
M5x6
2. Push the trim ring to left and pull out the
left part.
Dashboard
Disassemble the unit
1. Switch off the power.
2. Remove the trim ring.
3. Insert the removal keys straight back until
they lock, then pull the unit out.
4. Disconnect all the wires.