Installation Locations; Wiring Method - Aiphone JF-1MD Installation & Operation Manual

2
INSTALLATION
INSTALLATION
EINBAU
INSTALACIÓN
INSTALLATIE
2-1
1
2
+ 5 cm
(2")

Installation locations

1. Install the monitor station in a place where the screen is
not exposed to direct sunlight.
2. The monitor station has switches on both sides. Allow at
least 5 cm (2") of open space on either side.
3. Allow at least 15 cm (6") of vertical open space from the
center of the mounting bracket upward in order to mount
monitor station.
1.
2. The monitor station has switches on both sides. Allow at
least 5 cm (2") of open space on either side.
3. Allow at least 15 cm (6") of vertical open space from the
center of the mounting bracket upward in order to mount
monitor station.
1.
2. The monitor station has switches on both sides. Allow at
least 5 cm (2") of open space on either side.
3. Allow at least 15 cm (6") of vertical open space from the
center of the mounting bracket upward in order to mount
monitor station.
1.
2. The monitor station has switches on both sides. Allow at
least 5 cm (2") of open space on either side.
3. Allow at least 15 cm (6") of vertical open space from the
center of the mounting bracket upward in order to mount
monitor station.
3
+ 15 cm
JF-1MD / JF-1FD
(6")
+ 5 cm
(2")
1.
2. The monitor station has switches on both sides. Allow at
least 5 cm (2") of open space on either side.
3. Allow at least 15 cm (6") of vertical open space from the
center of the mounting bracket upward in order to mount
monitor station.
2-2
JF-DA

Wiring method

Wire the units from station-to-station (daisy-chained).
Wire the units from station-to-station (daisy-chained).
Wire the units from station-to-station (daisy-chained).
Wire the units from station-to-station (daisy-chained).
English
Wire the units from station-to-station (daisy-chained).
2-3
Français
Deutsch
Cable
1. Parallel or jacketed 2-conductor, mid-capacitance non-
Español
shielded cable is recommended. PVC jacket with PE
(polyethylene) insulated conductors is recommended.
2. Never use individual conductors, twisted pair cable or
coaxial cable.
3. When using a cable with unused conductors, it is
suggested to terminate both ends of unused pair(s) with a
120Ω resistor.
- 5 -
JF-1MD
2
(x2)
JF-1MD
JF-DA
A1 A1
JF-DV
A2 A2
JF-DVF
S
S
B1
B2
L
L
+
-
120
Nederlands
JF-1FD
6
JF-1SD
English
Français
Deutsch
Español
Nederlands
JF-1FD
B1
B2
L
L
+
-
120
English