Mb Intelligent Bios Iii) Menu - ECS A55F-M4 User Manual

M.I.B III (MB Intelligent BIOS III) Menu
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
Main
CPU Ratio/Voltage
Memory Clock
Memory Timing Configuration
Memory Clock DCT0 is :
Command Rate
CAS# Latency (tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
Memory Clock DCT1 is :
Command Rate
CAS# Latency (tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
CPU Over-clocking Func.
IGD Over-clocking Func.
CPU Ratio/Voltage (Auto)
This item is used to set the CPU Ratio/Voltage.
Memory Clock (Auto)
This item is used to set the memory clock.
Memory Timing Configuration
This item shows the information of Memory Timing.
CAS Latency (tCL) (9)
This item determines the operation of DDR SDRAM memory CAS (column address
strobe). It is recommended that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
Memory Clock DCT0 is: (None)
This item shows current memory clock of DCT0.
Memory Clock DCT1 is: (DDR-1333/667Mhz)
This item shows current memory clock of DCT1.
Command Rate (N/A / 1T)
This item shows the command rate.
RAS# to CAS# Delay (tRCD) (N/A / 9)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
Row Precharge Time (tRP) (N/A /9)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
RAS# Active Time (tRAS) (N/A /24)
This item specifies the RAS# active time.
CPU Over-clocking Func. (Disabled)
This item enables or disables CPU over-clocking function.
IGD Over-clocking Func. (Disabled)
This item enables or disables IGD over-clocking function.
44
Advanced Chipset
DDR-1333/667Mhz
A55F-M4 USER MANUAL
M.I.B III Boot
Auto
Auto
Auto
None
N/A
N/A
N/A
N/A
N/A
1 T
9 CLK
9 CLK
9 CLK
24 CLK
Disabled
Disabled
Security Exit
: Select Screen
/Click: Select Item
Enter/Dbl Click : Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit