Table of Contents
Advertisement
Assembly & Set-Up
Contents of Carton
•
One Tiller
•
One Engine Operator's Manual
NOTE: Stand behind the tiller as if you were going to operate
it. Your right hand corresponds to the right side of the tiller and
your left hand corresponds to the left side of the tiller.
NOTE: This operator's manual may cover various models of tillers.
The machines illustrated may vary slightly from your tiller.
NOTE: The tiller is shipped without gasoline or oil in the engine.
Fill up gasoline and oil as instructed in the accompanying engine
manual before operating your machine.
Assembly
Handle
1.
Remove the handle crank, bolt, washer, retainer bracket
and the flange lock nuts from the lower handle. See
Fig. 3-1.
Washer
Bolt
Handle Crank
Figure 3-1
•
One 20 oz. bottle SAE 30W oil
2.
Nuts
Retainer
Bracket
3.
4.
•
One Tiller Operator's Manual
Position the upper handle onto the lower handle. See Fig.
3-2. Align the holes on the lower handle with the holes on
the upper handle.
Washer
Bolt
Handle Crank
Figure 3-2
Insert the handle crank through the lower hole on the
handle and secure with the nut removed in step 1. See
Fig. 3-2.
Insert the bolt and washer through the hole in the handle
and secure with the retainer bracket and then the upper
nut removed in step 1. See Fig.3-2.
3
Retainer
Bracket
Nuts
6
Advertisement
Table of Contents
