Operating Your Snow Thrower - Troy-Bilt Storm 7524 Operator's Manual

Always release the traction control before
IMPORTANT:
changing speeds.
Auger Control
The auger control is located on the left
handle. Squeeze the auger control to
engage the augers; release to
disengage. Traction control must also
be released in order to stop the auger.
Shift Lever
The shift lever is located in the center
of the handle panel and is used to
determine ground speed and direction
of travel. It can be moved into any of
eight positions.
Always release traction
IMPORTANT:
the control before changing speeds.
Forward: The snow thrower has six
forward (F) speeds. Position one (1) is
the slowest and position six (6) is the
fastest.
Reverse: The snow thrower has two
reverse (R) speeds—R1 is the slower
of the two.
Discharge Chute
The angle of the upper discharge chute controls the
distance that snow is thrown. Tilt the discharge chute
up for greater distance; tilt it down for less distance.
Chute Crank
The chute crank is located on the left
side of the snow thrower. Use it to
change direction in which snow is
thrown. Avoid targetting persons,
animals or cars and buildings.
SECTION 4: OPERATING YOUR SNOW THROWER
Read and understand all instructions and warnings on
the machine and in this manual before operating the
snow thrower.
Gas & Oil Fill-Up
• Service the engine with gasoline and oil as
instructed in the engine manual shipped with the
snow thrower.
WARNING:
Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never
fuel machine indoors or while the engine is hot
or running. Extinguish cigarettes, cigars, pipes
an other sources of ignition.
Chute Tilt Control
The distance snow is thrown can be
changed by adjusting the angle of the
chute assembly. Move chute tilt control
forward to decrease distance, and
toward the rear to increase distance.
Chute Clean-Out Tool
The chute clean-out tool is designed to clear a clogged
discharge chute. Refer to page 10 for details.
6
5
4
3
2
1
F
Skid Shoe
The skid shoe position has to be determined by the
R R1
condition of the ground from where snow will be
removed. Higher the snow level, lower will be the skid
R2
shoe. Adjust it accordingly.
Headlight
(Model 8526 only)
The headlight is on whenever the engine is running.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine.
Safety Ignition Key
The safety ignition key must be fully inserted in the
switch before the unit will start. Remove key when snow
thrower is not in use. Do not turn the key.
C L O C K W I S E T O
DISCHARGE LEFT
COUNTER CLOCKWISE
TO DISCHARGE RIGHT
IMPORTANT:
equipped with a plastic fuel tank insert for
shipping purposes. Please discard it
before filling up gasoline for the first time.
To Start Engine
NOTE: If unit shows any sign of motion (drive or
augers) with the clutch grips disengaged, shut engine
off immediately. Readjust as instructed in the Final
Adjustments in the Assembly Section.
• Attach spark plug wire to spark plug. Make certain
the metal loop on end of the spark plug wire (inside
the boot) is fastened securely over the metal tip on
the spark plug.
8
WARNING:
Never use your hand to clear a
clogged discharge chute. Shut off engine and
remain behind handles until all moving parts
have stopped before unclogging.
Your snow thrower is