Remote Control Range; Loading Batteries; General Information Of Rc7300Sra To Sr6400 - Marantz SR6400 User Manual

REMOTE CONTROL RANGE

The distance between the transmitter of the
remote control and the IR SENSOR of the SR6400
should be less than 5 meters. If the remote control
is pointed in a direction other than the IR SENSOR
or if there is an obstacle between them, use of the
remote control may not be possible.
Remote-controllable range
SR6400
60°
Remote control unit (RC7300SRa)

LOADING BATTERIES

The life of the batteries used with the remote control
is about 4 months with normal use. Also be sure to
replace batteries earlier when you notice that they
are getting weak.
1.
Remove the back cover.
2.
Insert the new batteries (AA type) with correct
(+) and (–) polarity.
3.
Close the cover until it clicks.
Note:
• The supplied batteries are shipped to confirm the
initial operation. Therefore, the supplied batteries
will be consumed quickly.
GENERAL INFORMATION OF
RC7300SRa TO SR6400
To control the SR6400 by your RC7300SRa, you
have to select the device AMP or TUNER by
pressing the function selector button. Please refer
below for the details in AMP and TUNER mode.
AMP MODE
POWER ON/OFF Turns the SR6400 on and off
POWER ON
POWER OFF
V-OFF
EQ
7.1/6.1 IN
SLEEP
A/D
DISP./RDS
Surround mode
(0-9)
S-DIRECT
NIGHT(+10)
MUTE
BASS 34
TREBLE 34
VOL 34
MENU/OSD
Cursor
OK
SETUP
CH SEL
TEST
EXIT
SPKR A/B
ATT
Function selector Selects a particular source component
TUNER MODE
0-9
DISP./RDS
F.DIR/SEAR
PTY
MEMO
CL
T.MODE
P.SCAN
CHANNEL/SKIP • Selects a preset station
TUNE/SEARCH Tunes a station
TUNER
(*): European model only
Turns the SR6400 on
Turns the SR6400 off
Turns on or off the Video OFF mode
Turns on or off the HT-EQ mode
Selects the 6.1CH IN
Sets the sleep timer function
Switches between the analog and digital inputs
Changes the front display mode
Selects the surround mode
* DSP button is unavailable to SR6400.
Selects the Source Direct mode
Turns on or off the NIGHT mode
Decreases the sound temporarily
Adjusts the tone control of low frequency sound
Adjusts the tone control of high frequency sound
Adjusts the over all sound level
Displays the current setting on the monitor
Moves the cursor for settings in the "On screen display" mode
• Enters the "On screen display"
•Confirms the settings in "On screen display" mode
Same as the OK button
Calls up SETUP MENU and adjusts speaker levels or 6.1ch input level
Enters the test tone menu
Exits from the SETUP MAIN MENU
Selects the speaker system
Reduces the input level
Inputs the numeric #s
Selects the display mode in RDS (*)
Selects the "Frequency direct input"
Displays the programmed information of the current station (*)
Enters the tuner preset memory numbers
Clears the inputting
Selects the auto stereo mode or mono mode
Starts preset scan
• Changes a PTY type
Selects a frequency band
9