Connecting Audio Components - Marantz SR4021 User Manual

CONNECTING AUDIO COMPONENTS

Turn table
CD player
CD recorder
Tape Deck
The output audio signal from the RECORDER 1 OUT jack and the RECORDER 2 OUT jack is the same signal
which is currently selected.
Caution:
• Do not connect this unit and other components to mains power until all connections between components have been
completed.
Notes:
• Insert all plugs and connectors securely. Incomplete connections may make noise.
• Be sure to connect the left and right channels properly.
Red connectors are for the R (right) channel, and white connectors are for the L (left) channel.
• Be sure to connect input and output properly.
• Refer to the instructions for each component that is connected to this unit.
• Do not bind audio/video connection cables with power cords and speaker cables this will result in generating a hum
or other noise.
CONNECTING PRE OUT/MAIN IN JACKS
ANTENNA
AM
AUX
IN
GND
FM (75 )
GND GND
AUDIO AUDIO
PHONO PHONO
IN IN IN IN OUT OUT IN IN OUT OUT IN
IN IN
L L
R R
CD RECORDER 1 RECORDER 2 AUX
(CD-R) (TAPE)
Connecting with external power amplifi er
This receiver has enough power for normal listening but PRE OUT jacks are prepared to connect external
power amplifi ers for higher power output. In such a case, connect these jacks to the MAIN IN jacks or AUX IN
jacks of the power amplifi er.
Connecting with graphic equalizer
Use PRE OUT and MAIN IN jacks to connect a graphic equalizer or other analog audio processor.
Note:
When not used, leave these jacks connected with the supplied connecting pins.
Graphic equalizer
or
processor
OUT IN
L L
R R
R L R L
L R L R
REMOTE
VIDEO
CONTROL
IN
DVD VCR MONITOR
IN IN OUT OUT
OU
IN IN OUT
DVD VCR PRE PRE MAIN MAIN
OUT OUT IN IN
9