Basic Connections; Connecting Audio Components; Connecting Speakers - Marantz SR5023 User Manual

ENGLISH

BASIC CONNECTIONS

CONNECTING AUDIO COMPONENTS

Turn table
L R
PHONO
OUT
R
L
CD player
L R
ANALOG
OUT
R
L
DVD player
L R
AUDIO
OUT
Satellite tuner
L R
AUDIO
OUT
L R
CD recorder ANALOG
OUT
L R
ANALOG
IN
Caution:
• Do not connect this unit and other components to mains power until all connections between components have been
completed.
Notes:
• Insert all plugs and connectors securely. Incomplete connections may make noise.
• Be sure to connect the left and right channels properly.
Red connectors are for the R (right) channel, and white connectors are for the L (left) channel.
• Be sure to connect input and output properly.
• Refer to the instructions for each component that is connected to this unit.
• Do not bind audio/video connection cables with power cords and speaker cables this will result in generating a hum
or other noise.
8
PHONO GND PHONO GND
ANTENNA ANTENNA
FM ( ( 75 Ω ) )
FM 75Ω GND AM GND AM
PHONO PHONO CD CD DVD DVD DSS DSS AUX AUX RECORDER 1 RECORDER 1
(CD-R) (CD-R)
L L L L
L
R R R R
R
IN IN IN IN IN IN IN IN IN IN IN IN OUT OUT
L
R
R L
L
R
R L
L
R
R L
L
R
L
R
L R

CONNECTING SPEAKERS

PHONO GND PHONO GND ANTENNA ANTENNA
FM ( ( 75 Ω ) )
FM 75Ω GND GND AM AM
PHONO PHONO CD CD DVD DVD DSS DSS AUX AUX
L L L L
R R R R
IN IN IN IN IN IN IN IN IN IN
MODEL NO. SR5023 MODEL NO. SR50
L L
Powered
subwoofer
R R
CONNECTING SPEAKER WIRE
1. 2.
10 mm
(3/8inch)
3. 4.
1.
Strip away approx. 10 mm (3/8inch) of wire
insulation.
2.
Twist the bared wire ends tight, to prevent short
circuits.
3.
Loosen the knob by turning it counterclockwise.
4.
Insert the bare part of the wire into the hole in
side of each terminal.
5.
Tighten the knob by turning it clockwise to
secure the wire.
MODEL NO. SR5023 MODEL NO. SR5023
SPEAKER SYSTEMS SPEAKER SYSTEMS
N N
RECORDER 1 RECORDER 1 SUB WOOFER SUB WOOFER
(CD-R) (CD-R)
PRE OUT PRE OUT
R R L L
L L
R R
SPEAKERS IMPEDANCE : 8-16 OHMS SPEAKERS IMPEDANCE : 8-16 OHMS
IN IN OUT OUT
Right Left
Caution:
• Be sure to use speakers with the specifi ed impedance
as shown on the rear panel of this unit.
• To prevent damage to circuitry, do not let the bare
speaker wires touch each other and do not let them
touch any metal part of this unit.
• Do not touch the speaker terminals when the power
is on. It may cause you to receive an electric shocks.
5.
• Do not connect more than one speaker cable to one
speaker terminal. Doing so may damage this unit.
Note:
Be sure to connect the positive and negative cables for
the speaker properly. If they are miss-connected, the
signal phase will be reversed and the signal quality
will be corrupted.
CONNECTING A SUBWOOFER
Use the PRE OUT SUBWOOFER jack to connect a
powered subwoofer (power amplifi er built in).
AC IN AC IN
REMOTE CONTROL REMOTE CONTROL
IN IN
OUT OUT
AC OUTLET AC OUTLET
230V 230V 50/60Hz 50/60Hz
SWITCHED SWITCHED
150W 0.65A MAX. 150W 0.65A MAX.