Samsung AJ036JCJ5 Series Installation Manual page 6

Table of Contents

Advertisement

◆ Choose a position that enables the piping and cables to be easily connected to the indoor unit and the recommended
length will be respected.
◆ Install the outdoor unit on a flat, stable surface that can support its weight and does not generate any unnecessary
noise and vibration.
◆ Position the outdoor unit so that the air flow is directed towards the outside, as indicated by the arrows on the top of the unit.
◆ Maintain sufficient clearance around the outdoor unit, as indicated in page 8.
◆ Make sure that the water dripping from the drain hose runs away correctly and safely.
◆ When installing the outdoor unit near seashore, make sure it is not directly exposed to sea breeze. If you can not find a adequate
place without direct see breeze, protection wall should be constructed.
◆ Install the outdoor unit in a place (such as near buildings etc.) where it can be prevented from sea breeze which can damage the
outdoor unit.
Outdoor uni
Sea breeze
Sea
◆ If you cannot avoid installing the outdoor unit by the seashore, construct a protection wall around to block the sea breeze.
Protection wall
Sea breeze
Sea
◆ Install the outdoor unit in a place where water can drain smoothly.
※ If you cannot find a place satisfying above conditions, please contact manufacturer. Make sure to clean the sea water and the
dust on the outdoor unit heat exchanger and spread corrosion inhibitor on heat exchanger. (At least one time per one year.)
◆ You have just purchased a Free Joint Multi air conditioner and it has been installed by your installation specialist.
◆ This device must be installed according to the national electrical rules.
◆ Max input power & current is measured according to IEC standard and input power & current is measured
according to ISO standard.
◆ More than 2 indoor units should be installed when you use Free Joint Multi air conditioner.
◆ Our units must be installed in compliance with the spaces indicated in the installation manual to ensure either
accessibility from both sides or ability to perform routine maintenance and repairs.
The units' components must be accessible and that can be disassembled in conditions of complete safety either for
people or things. For this reason, where it is not observed as indicated into the Installation Manual, the cost
necessary to reach and repair the unit (in safety, as required by current regulations in force) with slings, trucks,
scaffolding or any other means of elevation won't be considered in-warranty and charged to end user.
◆ With an outdoor unit having net weight upper than 60 kg(132 lbs), we suggest do not install it suspended on wall,
but considering floor standing one.
◆ When the outdoor unit is installed near seashore or in a place where sulfuric acid gas may leak, corrosion may occur
in outdoor unit and cause product malfunction.
Sea breeze
Sea
Outdoor unit
Protection wall should be constructed with a solid material such as
concrete to block the sea breeze and the height and the width of the
wall should be 1.5 times larger than the size of the outdoor unit. Also,
secure over 700 mm(27.5 inch) between the protection wall and the
outdoor unit for exhausted air to ventilate.
Outdoor unit
5

Advertisement

Table of Contents
loading

Table of Contents