Samsung AJ036JCJ5 Series Installation Manual page 19

Setting indoor unit address A
Setting indoor unit address manually
Setting option
(AJ**JNND**/AJ**JNAD**)
Entering mode for
setting option
High Temp Button
Low Temp Button
Setting option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3. Each time you press Low Fan button, 7-seg on left side is increased by "1" and each time you press High Fan button,
7-seg on right side is increased by "1".
4. You press button to move to the next setteing page.
5. After setting option, press
6. Press operation button
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
• Set the SEG1, SEG7 as ON status and SEG13, SEG19 as OFF status.
EX) Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting
option at the same time.
18
button to check whether the option code you input is correct or not.
with the direction of remote control for set.
Option setting mode
Mode change
High Fan Button
Low Fan Button