Press the "Start/Pause" button repeatedly to scroll through the list of the diagnostics mode:
Activations
--
1
2
NUMBER OF CYCLES
3
5 PULSE WASHING YES
4
5
6
7
Press the OK button to enter a specific Service Option.
Press Start/Pause to change the current setting.
Press OK to confirm the modification.
To quit diagnostics mode, press button S0 to turn off the appliance.
8.2
Alarms and activating individual components
1. Enter diagnostics mode
2. Press the OK button to display the alarms:
The display shows the last alarm that occurred (to decode the alarm, please see the table of
"Alarms").
3. Press the OK button again to display the second alarm that occurred
4. Press the OK button once more to display the third alarm that occurred
5. Press the OK button repeatedly to scroll through the list of electronic components, as shown in the table
below.
Activations
1
1 ERR CODE i 0
2
1 ERR CODE i 0
3
1 ERR CODE i 0
4
2 TEST ACTIVAT. 4
5
2 TEST ACTIVAT. 5
6
2 TEST ACTIVAT. 6
7
2 TEST ACTIVAT. 7
SOE/PR
LCD display
1 ALARM CODE ixx
3 LED TEST
4 LINE TESTS
Alternates with
6 EXTRA RINSE NO
BRIGHTNESS 10
CONTRAST 6
HARDNESS 5
LCD display
•
Shows the alarms stored and activation of the
system
•
Test of all LEDs and the display
•
Cancellation of all alarms stored
•
Selection of test cycle
•
Count of all cycles carried out
•
Enables/disables pulse washing
•
Enables/disables the extra rinse
•
Brightness setting
•
Contrast setting
•
Adjustment of the regenerating level depending on
the water hardness
Function enabled
Displays the last alarm that occurred (for example, no alarm)
Displays the last but one alarm that occurred (for example,
no alarm)
Displays the last but two alarm that occurred (for example,
no alarm)
Regenerating solenoid valve activated
Drain pump activated
Fill to water level solenoid valve activated
Heating element activated (only with water at full level!)
27
Feature
599 72 48-93