Vermont Castings VFF32LI Installation & Operating Instructions Manual page 42

VFF Vent Free Fireplace System
IPI SYSTEM
Flip the master switch to the
ON position
Press the wall switch to the
ON position
Cold climate switch
42
Make sure control board is
No beep or flashing
connected to battery pack wire
green light in about 5
seconds
adaptor is plugged into control
No beep
No sound from
valve indicating
pilot solenoid
opened
No spark at pilot
Pilot doesn't light
Main burner
doesn't light
No function
harness. Make sure AC
Check wiring connections
between switch and board
Check wiring connections
between valve and board
Inspect gray ignitor wire
connection at board and pilot.
Check gas supply.
Flame not engulfing flame
sensor or pilot flame too
Check the cold climate switch and control
TROUBLESHOOTING
Battery polarity wrong?
Batteries low?
AC adaptor plugged into
junction box?
Check that ground
Reconnect wire if disconnected.
wire has solid
Replace ignitor wire if damaged.
connection
Adjust sparker position such that the
spark is in the path of the gas flow or
Adjust sensor position or replace the
Reinstall batteries correctly.
Change batteries.
Plug the AC adaptor in
Correct wiring if necessary
Correct wiring if necessary
replace the pilot
pilot.
Replace cold climate switch
20308184