Miele T 8007 WP SUPERTRONIC Operating Instructions Manual page 52

Problem solving guide
Problem
There are humming
noises.
The display and the
sensors are not lit up
and the Start sensor is
flashing slowly.
The programme does
not start.
Power cut.
The display is in a
different language.
The interior drum
lighting does not
come on.
52
Possible cause
The compressor is
operating.
The display and sensor
illumination switch off to
save energy.
No obvious cause.
When power is restored, any programme which was
running will restart automatically.
A different language
has been selected.
The lighting switches
off automatically (to
save energy).
Access via a code has
been activated.
Remedy
These noises are quite
normal and do not indicate a
fault.
– Touch the Start sensor.
The display and sensors
will light up.
– See "Settings menu,
Display / keypad
illumination".
– Is the dryer switched on?
– Is the plug correctly
inserted into the socket
and switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
– If you cannot remedy the
problem, then there could
be a fault. Contact Miele
Service.
Set the language you want.
The flag symbol J will guide
you.
– Switch the dryer off and
then on again.
– If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
– When the code is entered
the lighting will come back
on.