Cleaning And Maintenance; Venting System; Cleaning Glass; Pilot And Burner Flames - Vermont Castings CSDV30SNVGCSB Installation And Operating Instructions Manual

CLEANING AND MAINTENANCE

NOTE: Make sure the gas valve knob is in the "OFF"
position. Wait at least five (5) minutes before start -
ing maintenance.

VENTING SYSTEM

A qualified agency should examine the venting system
annually.

CLEANING GLASS

Clean the ceramic glass periodically. Condensation will
sometimes form on the glass during a cold startup. This is
normal for all gas fireplaces and stoves. This condensation
often attracts dust and lint to the surface of the glass. The
initial paint curing of the appliance can also leave a slight
film on the glass. This is a temporary problem.
Your should clean the glass after the first two weeks of use.
After that, you should clean the glass no more than two or
three times a season. Use a mild glass cleaner to clean
the door. Do not use abrasive cleaners. They will damage
the glass surface.

PILOT AND BURNER FLAMES

Visually check pilot and burner flames periodically. Refer
to Figure 42 for typical pilot flame. Refer to Figure 43 for
typical burner flame.

FIREBOX CLEANING

1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set and rock wool in their correct
positions.
6. Replace door.
7. Relight pilot.
8. Turn on main burner.
Make sure clearances to combustibles allow
enough room for maintenance and service.
Carefully reassemble and reseal stove
properly after any cleaning or servicing.
20306757
CSDV Series Direct Vent Gas Stove
Allow glass to cool before cleaning.
Do not clean glass when it is hot.
Damage could occur.
Figure 39 -
FP1943
Pilot Flame Appearance
pilot flame
R E
M O
T E
C O
N T
R O
L
Figure 40 -
Typical Burner Flame Appearance
LG820
CSDV log flame
Thermocouple
Thermopile
P IL
O T
O F
F
31