Messages - Sony MHC-GTR88 Operating Instructions Manual

Optional components
There is no sound.
• Refer to General item "There is no
sound." (page 43) and check the
condition of the system.
• Connect the component properly
(page 10) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all
the way.
• Turn on the connected component.
• Refer to the operating instructions
supplied with the connected component
and start playing.
To reset the system to factory
settings
If the system still does not operate
properly after performing the above
measures or other troubles not described
above occur, reset the system to factory
settings. You cannot reset the system to
factory settings in Power Saving Mode.
1
Disconnect and reconnect the
power cord, and then turn on the
system.
2
Press x, ENTER, and "/1 at the
same time.
"COLD RESET" appears in the
display.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are reset to factory setting.
GB
46

Messages

One of the following messages may
appear or flash in the display during
operation.
Disc/Tape*/Timer
LOCKED
The disc tray does not open. Contact your
nearest Sony dealer.
NO DISC
There is no disc on the disc tray or you
have loaded a disc that cannot be played
back on this system.
NO STEP
All of the programmed steps have been
erased.
NOT IN USE
You have pressed a button those operation
is not allowed or invalid at this time.
OFF TIME NG
The Play Timer or Recording Timer start
and stop times are set to the same time.
PUSH SELECT
You tried to set the clock or timer during
timer operation.
PUSH STOP
You tried to perform an operation that can
be performed only when the system is
stopped.
READING
The system is reading information of the
disc. Some buttons are not available.
SET CLOCK
You pressed CLOCK/TIMER SELECT
before the clock is set.
SET TIMER
You pressed CLOCK/TIMER SELECT
before the Play Timer or Recording Timer
is set.