Wireless-G Router for 3G/UMTS Broadband
11. Connect the power adapter to the Router's Power port. Plug the other end into an electrical outlet.
Click the Next button.
12. Make sure the Power, Internet, and at least one of the numbered LEDs on the Router light up. If they do not
light up, make sure the cables are securely connected.
The Power LED will flash for a few seconds while the Router goes through its self-diagnostics test. This LED
will be solidly lit when the self-test is complete. If it does not stop flashing, refer to "Appendix A:
Troubleshooting."
Click the Next button.
Chapter 5: Setting up the Wireless-G Router for Broadband WAN and 3G/UMTS or GPRS Ser-
vice
Figure 7-9: Power on the Router Screen
Figure 7-10: Check the Router's Status Screen
44