Related Manuals for CONCORD Ponderosa 52PD
Summary of Contents for CONCORD Ponderosa 52PD
-
Page 1: Installation Instructions
Ponderosa ™ ® 52PD Owners Manual Installation Instructions Part Number: PL-3243 A Commitment to Excellence... - Page 2 50 pounds of moving weight and marked “Acceptable for Fan Support”. If you have any questions, outlet boxes and support systems for ceiling fans are available at most hardware and do-it-yourself centers. In most cases, your Concord ® dealer will have all the necessary products for the proper and safe installation of your ceiling fan.
- Page 3 This ceiling fan was not designed for installation in any location where it might be exposed to moisture or high humidity. Installation in this type of location could be UNSAFE, will most likely damage the fan and its finish... and will VOID YOUR WARRANTY. Every effort has been made to provide you with proper instructions for the safe installation of this ceiling fan.
-
Page 4: Turned Off
Have you Ceiling Canopy Mounting Screw TURNED OFF the Electricity? Fig. 1 Junction Box Step 1 Attach the mounting bracket Loosen the two canopy mounting screws on the downside face of the mounting bracket. Back them out about half way. This will allow for easier installation of the ceiling canopy later (see figure 1). - Page 5 Pull the electric wires in the junction box down through the mounting bracket and then bend them up and back out of the way. This will leave the mounting bracket open and ready to receive the ceiling fan (see figure 4). If you are using an extended support rod, (longer than the one supplied with your fan) remove the half ball from the small support rod that came...
- Page 6 Mounting Bracket Step 3 Hanging the Fan Body Keyway Pin Notice the half ball on the end of the support rod is grooved down one side (see figure 6). This Keyway fits over the small keyway pin Ball Hanger on the inside of the mounting bracket and keeps the ceiling fan from spinning on the Support Rod mounting bracket.
- Page 7 Step 4 Making the Electrical Connections Black To operate your ceiling fan with the pull chain(s) and switches mounted on your fan, follow the White instructions below: Black Blue If you require or would like to use a different method of con- trolling your fan, refer to the OPTIONAL ELECTRICAL Ground...
- Page 8 Step 6 Fan Blade and Blade Arm Assembly Screw Most CONCORD fans are supplied with a reversible blade finish. Choose the blade finish that you prefer and attach as follow: Blade Attach each fan blade to a blade arm with three (3) 3/16”...
- Page 9 Step 7 Fan Blade Assembly Installation Remove the large screws in the face of the motor. Discard any rubber blocks attached to these screws. The rubber blocks are installed at the factory to stabilize the motor during ship- ment. Select the correct mounting pattern and attach each blade to the motor face using the two screws attached to the blade arm (see figure 13).
- Page 10 Step 8 Electrical Switch Housing Installation Back off (loosen) the three screws on the electrical housing mounting plate attached to the motor shaft (see figure 15). A color coded wire connector (female) is located inside the electrical switch housing (see figure 14), a male connector extends from the mounting plate.
-
Page 11: Important Note
SWITCH THAT HAS BEEN DESIGNED FOR USE WITH CEILING FANS Your dealer carries a number of different types of CONCORD wall switches that have been Fig. 17 designed and tested for use with our products. To obtain the best performance electrical com- ponents should be matched for output, for that Fan &... -
Page 12: Maintenance
No part of this publication may be produced, transmitted, transcribed, stored in a retrieval system, or translated into any language ® in any form by any means without the written permission of Great 2000 Enterprises, Inc.. Concord Fans and Lighting is a division of Great 2000 Enterprises, Inc.