Table of Contents
Advertisement
•
Be extremely careful when removing the lamp housing. In the unlikely
event that the lamp ruptures, small glass fragments may be generated.
The lamp module is designed to contain most of these fragments, but
use caution when removing it. Before replacing a ruptured lamp, clean
the lamp compartment and dispose of cleaning materials. Wash hands
after lamp replacement. This product has a lamp which contains a very
small amount of mercury. Dispose of it as required by local, state or fed-
eral ordinances and regulations. For more information see
www.eiae.org.
5
Detach the lamp connector from the projector by depressing the locking
tab on the connector and lightly pulling it free.
6
Carefully remove the lamp module by grasping and lifting the metal
bail wire. Dispose of the lamp in an environmentally proper manner.
7
Install the new lamp module, making sure that it is properly seated. Be
careful not to touch the interior components of the projector.
8
Snap the bail wire back into its flat position against the lamp module.
9
Re-attach the lamp connector to the projector. The locking tab should
engage when the connector is fully plugged in.
10
Tighten the screw on the lamp module.
11
Replace the lamp door.
12
Plug in the power cable then press the Power button to turn the projec-
tor back on, then reset the lamp hour timer.
Resetting the lamp timer
If the lamp timer has reached the maximum number of hours for the projec-
tor lamp, the LED on the projector's keypad will show a lamp error (see
"LED behavior and meaning" on page 16). To reset the lamp timer, press the
decrease volume button on the keypad and the increase volume button
simultaneously for 10 seconds. You can also navigate to the Settings>Ser-
vice menu and select Lamp Reset to reset the lamp timer.
disconnect lamp connector
remove module using bail wire
41
reset lamp time in Service menu
Advertisement
Table of Contents
