Using The Remote Control - Ask Proxima C170 User Manual

Ask user's guide projector c170
Table of Contents

Advertisement

Using the remote control

The remote uses two (2) provided AA batteries. They are easily installed by
sliding the cover off the remote's back, aligning the + and - ends of the bat-
teries, sliding them into place, and then replacing the cover.
To operate, point the remote at the projection screen or at the projector (not
at the computer). The range of optimum operation is about 30 feet (9.14m).
Previous and Next buttons allow you to navigate through your PowerPoint
presentation while in Slide Show mode. Connect the USB connector on the
computer cable to your computer to use these buttons. When you do this for
the first time, the Add New Hardware wizard may appear. See page 10 for
details on loading the correct USB drivers.
Press the remote's Menu button to open the projector's menu system. Use
the arrow buttons to navigate, and the Select button to select features and
adjust values in the menus. See page 30 for more info on the menus.
The remote also has a Power button to turn the projector on and off (see
page 16 for shutdown info), Volume and Mute buttons to control the sound,
and a Source button to switch between sources.
Two presentation-specific features are also provided. Use the Blank button
to display a blank screen instead of the current slide (you can choose which
color is displayed, see page 37); use the Effect button to invoke a user-defin-
able action, such as freeze or aspect ratio (see page 38 to learn to program
this button).
previous button
navigation
buttons
Troubleshooting the remote
Make sure the batteries are installed in the proper orientation and are
not dead. The LED at the top of the remote lights when any button is
pressed when the battery power is adequate.
Make sure you're pointing the remote at the projector, not the com-
puter, and are within the remote range of 30 feet (9.14m).
If you are trying to advance PowerPoint slides, make sure the USB por-
tion of the M1 computer cable is connected and the correct drivers are
installed.
26
next button

Advertisement

Table of Contents
loading

Table of Contents