Attaching The Shelf Brackets; Left And Right Shelf Brackets Installed On The Cabinet Rails - IBM SAN768B-2 Installation, Service And User Manual

5. Use the lift tool to transport the new chassis to the installation area. Doorways

Attaching the shelf brackets

Complete the following steps to install the shelf brackets to the cabinet rails:
1. Find the left and right rack mount shelf brackets ( A and B in Figure 4) in
2. Loosen the adjusting screws on both brackets enough to allow the brackets to
Figure 4. Left and right shelf brackets installed on the cabinet rails
3. Position the shelf brackets ( A and B ) with the adjustable ends at the intake
18
SAN768B-2 Installation, Service, and User Guide
Note: The standard packaging does not incorporate a wood pallet and pallet
brackets. The chassis sits on top of a plastic shipping tray.
must be wider than 91 cm (36 in.) to accommodate the chassis on the shipping
tray.
the 14U rack mount kit. These brackets are adjustable to allow for different
cabinet depths.
slide easily to adjust the length.
Rail
E
E
(4x) (4x)
(4x) (4x)
Adjustable ends
A
Shown with
Round Hole Rails
aisle side of the cabinet (see Figure 4) and attach them to the cabinet rails.
v For rails with round holes: Use eight screws with lock washers ( E ) for each
bracket, four at each end. Tighten the screws to a torque of 92 cm-kg (80
in.-lb).
v For rails with square holes: Use eight screws ( G ) eight alignment washers
( H ) for each bracket, four at each end. Tighten the screws to a torque of 92
cm-kg (80 in.-lb).
Setup for rails with square holes
H
G
B
(4x) (4x)
E
(4x) (4x)
E