Figure 31. Removal and replacement of the blower assembly
Installing a blower assembly
Complete these steps to install a blower assembly.
1. Orient the blower assembly and slide it into the chassis, pushing firmly to
2. Verify that the power LED displays a green light.
3. Use the screwdriver or your fingers to tighten the captive screws.
Removing and installing a WWN bezel and WWN card
Note: The World Wide Name (WWN) cards contain fully redundant circuits and
Time and items required
Allow approximately 20 minutes to replace a WWN card. The following items are
needed to install a WWN card:
v ESD grounding strap
v #2 Phillips screwdriver (required only for some versions of the WWN card)
ensure that it is seated.
normally do not require installation. Two WWN cards are located beneath
the WWN bezel.
Chapter 5. Removing and installing components
89