Dic Warnings And Messages; Ac (Air Conditioning) Off; Abs (Antilock Brake System) Fault - Chevrolet 2010 Colorado Owner's Manual

DIC Warnings and Messages

Messages are displayed on the DIC to notify the driver
that the status of the vehicle has changed and that
some action may be needed by the driver to correct
the condition. Multiple messages may appear one
after another. The messages are displayed for
several seconds each.
Some messages may not require immediate action, but
you should press and release the trip odometer reset
stem to acknowledge that you received the messages
and to clear them from the display. Each message must
be acknowledged individually.
Some messages cannot be cleared from the DIC
display because they are more urgent. These messages
require action before they can be cleared. You should
take any messages that appear on the display seriously
and remember that clearing the messages only makes
the messages disappear, not correct the problem.
The following are the possible messages that can be
displayed and some information about them.
4-36

AC (Air Conditioning) OFF

This message displays when the engine coolant
temperature is too high and the air conditioning in your
vehicle needs to be turned off. See Engine Overheating
on page 6-32 and Climate Control System on page 4-16
for more information. This message displays along with
the ENG HOT message.

ABS (Antilock Brake System) FAULT

This message displays if there is a problem with
the Antilock Brake System (ABS). Check the ABS as
soon as possible and have your vehicle serviced by your
dealer/retailer. See Brakes on page 6-36 and Antilock
Brake System (ABS) Warning Light on page 4-25
for more information. Press and release the reset stem
to acknowledge the message and clear it from the
display.
BRAKES
This message displays if there is a problem with the
brakes. Check the brakes as soon as possible and have
your vehicle serviced by your dealer/retailer. See Brakes
on page 6-36 and Brake System Warning Light on
page 4-24 for more information. Press and release the
reset stem to acknowledge the message and clear it from
the display.