Table of Contents
Advertisement
6. System Setu
6.1 System Configurations
The "System Configurations" page provides users options to setup the device
quickly and properly. After properly configuring all settings in all the sub-pages,
users should expect a fully working network video recorder that is ready to
manage cameras on the network. We will start by configuring its network
settings to make sure it works correctly in your network. Next, we will help yo
adjust the system time so videos will be recorder with correct timestamp. T
better secure the system for unwanted disturbance, we will guide you on
setting up user's account and privileges to prevent settings gets altered by
users other than the system administrator. Lastly, we will tell you what you
should expect after installing a hard disk and how to prepare the hard disk for
th
e video recording.
6.1
.1 Network Settings
Y
ou need to adjust settings in this page for the device to work properly in your
n
etwork. It is critical that settings here are configured correctly based on your
n
etwork configurations so that the recorder can be administered through the
lo
cal area network and cameras can be connected from it.
B
y default, the recorder is set to obtain IP address from DHCP server, it should
b
e sufficient in most network environments, and most likely you should not
n
eed to alter anything in this page. To locate the recorder, simply use the IP
U
tility with steps described in page 13.
p
u
o
Advertisement
Table of Contents
