Planet Networking & Communication NVR-25 Series Manual

H.265 25-ch 4K Network Video Recorder
NVR-2500/NVR-2516P
►
1. Introduction
Thank you for purchasing PLANET H.265 25-ch 4K Network Video
Recorder. The "NVR-25xx series" is used as an alternative name
in this Quick Installation Guide. The following is the NVR-25xx
series:
NVR-2500 H.265 25-ch 4K Network Video Recorder
H.265 25-ch 4K Network Video Recorder with
NVR-2516P
16-Port PoE
2. Package Contents
Open the box of the NVR-25xx series and carefully unpack it. The
box should contain the following items:
z The NVR x 1
z Quick Installation Guide x 1
NVR-2500
NVR-2516P
Figure 3-1: Hard Disk Installation
4. Requirements
z Workstations running Windows XP/2003/2008/Vista/7/8/10, MAC
OS X or later, Linux, UNIX, or other platforms are compatible
with TCP/IP protocols.
z Workstations are installed with Ethernet NIC (Network Interface
Card).
z Ethernet Port Connection
 Network cables -- Use standard network (UTP) cables with
RJ45 connectors.
– 1 –
– 3 –
z HDD Screw Package x 1
z Power Cord x 1
z Power Adapter x 1 (NVR-2500 only)
z Bracket & Screw Package x 1 (NVR-2516P only)
If any item is found missing or damaged, please contact your local
reseller for replacement.
3. Hard Disk Installation
The hard disk is installed as shown in Figure 3-1.
(1) Unscrew the cover to open the cover.
(2) Connect one end of the hard disk data cable and power cable
to the motherboard, and connect the other end to the hard
disk.
(3) Turn over the chassis, mount the hard disk in the indicated
position and screw it tightly.
(4) Now turn over the chassis again and cover it with screws.
1. Before installation,
disconnected.
2. Use the NVR dedicated hard drive for monitoring
Note
recommended by the device manufacturer.
 The above PC is installed with Web browser.
It is recommended to use Internet Explorer 8.0 or
above to access the NVR-25xx series. If the Web
interface of the NVR-25xx series is not accessible,
please turn off the anti-virus software or firewall and
Note
then try it again.
5. Starting Web Management
The following shows how to start up the Web Management of the
NVR-25xx series. Note the NVR-25xx series is configured through
an Ethernet connection. Please make sure the manager PC must be
set to the same IP subnet address.
Ethernet Switch
User PC
(192.168.0.X)
Figure 5-1: IP Management Diagram
1. Make sure the input voltage matches the NVR
consumption. Connect the device to the monitor and
the power adapter (if available). Plug in the power
and switch on the power button (if available) for the
device to boot up.
Note
2. It is recommended that you refer to international
standards for power supply input with stable voltage
values and low ripple interference.
make sure the power
– 2 –
H.265 25-ch 4K NVR
– 4 –
is