Craftsman 137.415030 Operator's Manual page 26

5. Place the riving knife (3) on the
mounting bracket (4) located behind
the saw blade. The two pins (5) on
the bracket should fit into the slot on
the riving knife. (Fig. Q)
6. Make sure the riving knife (3) is in
its highest position.
7. Insert the set plate (6), making sure
the two outer holes fit into the two
pins on the mounting bracket.
8. Insert the washer (7) into the lock
lever (8) and insert into the middle
hole of the set plate (6) and tighten.
9. Loosen the blade lock knob (2) and
return the blade to 0 ° and lock.
10.Place the table insert back into
position.
WARNING I
o To avoid the lock lever interfering
with the table insert, after tighten
the riving knife, position the lock
lever pointing downward before
using saw. Failure to maintain a
level insert can result in serious
injury to the operator.
o The lever can be pulled out to
allow it to be turned to a new
position downward. (Fig. R)
Fig. Q
cavity side face
to lock lever
4
i
i
7
Fig. R
BLADE GUARD AND ANTI=KICKBACK
PAWLS ASSEMBLY (FIG. S, T, U, V)
WAR.I.G 1
To avoid injury from an accidental start,
make sure the switch is in the OFF
position and the plug is disconnected
from the power source outlet.
e When installing the blade guard,
cover the blade teeth with a piece of
folded cardboard to protect yourself
from possible injury.
e Never operate this machine without
the blade guard in place for all
through sawing operations.
Installing the blade guard and anti=
kickback pawls assembly
(Fig. S, T, U, V)
1. Make sure the blade is elevated to
its maximum height and the bevel is
set at 0 °. Make sure the blade lock
knob is tight.
2. Raise the riving knife (1) to its highest
position (through cut position). Take
the anti-kickback pawls assembly
and lift up the locking lever (2)
located on top. (Fig. S)
26