Table of Contents
Advertisement
5. Foldthestandslowly downward a s
shown in Fig.F.
6. Movethesawtothedesired
location foroperation o r storethe
sawin a dryenvironment byusing
the leftsidestandhandles (10).
Fig.F
Tra nsporti ng
8
_.
_, 1 0->_
Folding
STORAGE
Ripfenceandmitergauge(Fig.G)
Storage fortheripfence(1)andmiter
gauge(2)arelocated ontheleftsideof
thesawhousing.
Fig.
G
2
Extra saw blade and blade wrenches
(Fig. H)
1. Loosen and remove the knob (1) on
the right side of the saw housing.
2. Place blade wrenches (2), extra
blades (not included) onto the arbor.
Fig. H
1
Push stick (Fig. I)
A storage holder for the push stick (1)
is located on the left side of the
saw housing.
1. Store the push stick (1) by hanging
it on the holders (2) through the
holes (3)of the push stick (1).
Fig. I
Installing
the power cord storage
clamps (Fig. J)
1. Attach the power cord storage
clamp (1) into the hole set on the
rear side of the table saw base with
screw (2) and nut (3).
NOTE: The nut is placed inside
the base.
2. Repeat for the other clamp, to be
located on the bottom right on
saw base.
Advertisement
Table of Contents
