Advertisement
Available languages
Available languages
The door is difficult to open
There is interior moisture buildup
Explosion Hazard
Use nonflammable
cleaner.
Failure to do so can result in death, explosion, or fire.
•
Gaskets dirty or sticky? Clean gaskets and contact surfaces
with mild soap and warm water. Rinse and dry with soft
cloth.
The lights do not work
•
is a light bulb loose in the socket or burned out? See
"Changing
the Light Bulbs."
Temperature
is too warm
New installation? Allow 24 hours following
installation
for
the refrigerator
to cool completely.
Are the air vents blocked in either compartment? This
obstructs cold air movement between the compartments.
Remove any objects from in front of the air vents. See
"Ensuring Proper Air Circulation"
for the location of air
vents.
Door opened often or left open? Allows warm air to enter
refrigerator.
Minimize door openings and keep door fully
closed.
Large load of food added? Allow several hours for
refrigerator
to return to normal temperature.
Control(s) set correctly for the surrounding conditions? Adjust
the control(s) a setting colder. Check temperature
in
24 hours. See "Using the Control(s)."
The divider
between
the two
compartments
is warm
Internal
heaters
are used to reduce excess exterior
moisture.
If
still concerned,
call
for service.
NOTE" Some moisture buildup is normal.
Humid room? Contributes to moisture buildup.
Door opened
often or left open? Allows
humid
air to enter
refrigerator.
Minimize
door
openings
and keep door
fully
closed.
Control(s) set correctly for the surrounding conditions? Adjust
the control(s) a setting colder. Check temperature
in
24 hours. See "Using the Control(s)."
Are the air vents blocked in either compartment? This
obstructs cold air movement
between the compartments.
Remove any objects from in front of the air vents. See
"Ensuring Proper Air Circulation"
for the location of air
vents.
Was a self-defrost cycle completed? It is normal for
droplets to form on the back wall after the refrigerator
self-
defrosts.
There is water in the defrost drain pan
Is the refrigerator defrosting? The water will evaporate. It is
normal for water to drip into the defrost pan.
Is it more humid than normal? Expect that the water in the
defrost pan will take longer to evaporate.
This is normal
when it is hot or humid.
_,Wc_te_
The ice maker is not producing ice or not enough ice
•
Refrigerator
connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator
to water
supply and turn water shutoff valve fully open.
•
Kink in the water source line? A kink in the line can reduce
water flow. Straighten
the water source line.
•
Ice maker turned on? Make sure wire shutoff arm or switch
(depending
on model) is in the ON position.
•
New installation? Wait 24 hours after ice maker installation
for ice production to begin. Wait 72 hours for full ice
production.
•
Large amount of ice recently removed? Allow 24 hours for
ice maker to produce more ice.
•
Ice cube jammed in the ice maker ejector arm?
Remove ice from the ejector arm with a plastic utensil.
•
Reverse
osmosis water
filtration
system connected
to your
cold water
supply? This can decrease
water
pressure.
See
"Water
Supply
Requirements."
2O
Advertisement
