Whirlpool WFW8640BW2 Use & Care Manual page 12

USING YOUR WASHER
1 2, Touch and hold START to begin
wash cyc(e
)ii_;_;_;_))))))))j)
Hold to Start
Touch and hold START to start the wash cycle. To pause a
cycle in progress, touch START once, then touch and hold
again to continue the cycle. To cancel a cycle, touch POWER.
Once you touch and hold START, you will hear the door lock,
unlock, and lock again. The washer door will remain locked
during the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2
missed garments, you may do so while the
"Add Garment" light is lit.
Touch START once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and touch and hold START again to
restart the cycle.
Hold to Start
f13,
Remove garments promptly
after cycle is finished
for small items between the tub and the washer drum.
If you will be unable to remove the load [
promptly, use the TumbleFresh
TM
option. ;::'
If selected, the TumbleFresh
TM
option will [ TumbleFresh
tumble the load periodically for up to 6 hours.
To turn off the TumbleFresh
TM
option, touch POWER. To set the
washer so that the TumbleFresh
TM
option does not come on for
future cycles, touch TumbleFresh.
NOTE:
III The door will remain locked while the TumbleFresh
TM
option
is active. To cancel the option and unlock the door, touch
POWER.
[] A small amount of water may remain in the dispensers after
the wash cycle is complete. This is normal.
[] This washer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer to dry
between uses.
i
12