Whirlpool WFW8640BW2 Use & Care Manual page 11

8. Select CYCLE*
NORMAL
COLDWASH- -- WHITES
DEL_CATES -- HEAVY
DUTY
QU_CK
WASH TOWELS
DRAIN SANITIZE
& SPIN
CLEAN WASHER
with
_$_
Turn cycle knob to select your wash cycle. See "Cycle Guide"
for details on cycle features.
"10. Select any additional options*
.... I .... J I
Ce_nl_oost Extra Rinse TumbleF_esh Cycle Signal
/V ill tendril Hold _ seconds
for _,tton So_J ds
To add an option to the cycle, touch its name - CleanBoost with
Steam, Extra Rinse, TumbleFresh, or Cycle Signal. To remove
an option from the selected cycle, touch the option again.
9. Adjust settings, if desired* "1 "1. Setting a delayed wash
The display will show the default settings for the selected
cycle. To adjust a setting, touch its name - Wash Temp, Spin,
Soil, or Presoak. Adjusting settings will change the Estimated
Time Remaining. Tightly packing the load, unbalanced loads,
or excessive suds may also cause the washer to increase the
cycle time.
If you do not want to begin a cycle immediately, you may
choose the DELAY WASH option. This will delay the start
of the wash cycle by up to 8 hours.
To set a delayed wash:
1. Touch DELAY WASH + and - buttons to set the desired
delay time.
2. Touch and hold START to set the delay. The delay
countdown has started when the START light stops blinking.
*Not all options and settings are available with all cycles.
See "Cycle Guide" for available options and settings.
11