Kenmore 148.34176410 Use & Care Manual page 21

Connect the four burner ignition wires to the four sockets on the right side of the igniter. Connect the
remaining wire to the remaining open socket.
Place the ground wire through the slot as shown below. Loosen one control panel screw, install the
ground wire onto the screw, and retighten it to make a good connection.
Ground Wire
Install the doors
For each door, insert the bottom hinge pin into the hole in the bottom panel. Push up the top hinge
pin located under the bottom of control panel to get it into the hinge hole in the door. If necessary,
loosen screws on bottom panel magnet housingand adjust and retighten so that doors close
securely.
21