Removing the connection board
Prior to performing the following procedures, remove
the rear panel assembly.
1.
Disconnect the wire from connector CN102 on the
power board.
2.
Remove the two screws P
connection board.
Removing the battery board (1) / battery
board (2) (See Fig.20 and 21)
Prior to performing the following procedures, remove
the rear panel assembly.
1.
Remove the battery cover on the back of the rear
panel assembly.
2.
Remove the two screws Q
board (1).
3.
Pull out the battery board (1) and disconnect the wire
from inner connector CN401.
4.
Remove the two screws R and pull out the battery
board (2).
(See Fig.19)
and pull out the
retaining the battery
P
Fig.19
Fig.20
CN401
Battery board (1)
Q
Fig.21
RS-WP1WT
P
Connection board
CN112
Battery cover
Battery board (2)
R
1-11