RS-WP1WT
Removing the power board
Prior to performing the following procedures, remove
the rear panel assembly.
1.
Disconnect the wire from connector CN101, CN102
and CN103 on the power board.
2.
Remove the four screws O attaching the power
board.
3.
Remove the three screws O' attaching the heat sink.
4.
Disengage the two joints c and remove the heat sink
from the power board.
1-10
(See Fig.16 to 18)
CN102
CN101
Fig.16
O'
Fig.17
Joint c
Heat sink
Fig.18
O
CN103
O
Power board
O
Power board
Joint c