ATEN KN2124v User Manual page 40

KVM Over the NET™ User Manual
3. If you are using a KA7140 Adapter Cable, refer to page 260 for
setup and operation information.
4. The distance between the switch and the KVM Adapter Cable
must not exceed these lengths: KA7140: 300m; KA71xx: 50m;
KA91xx: 40m.
3. Plug the connectors on the KVM Adapter Cable into the appropriate ports
of the server you are installing. (See Adapter Cable Connection Diagram,
page 28.)
4. Plug a cable from the LAN or WAN into the KVM Over the NET™
switch's primary network interface socket.
5. (Optional) Plug another cable from the LAN or WAN into the KVM Over
the NET™ switch's backup (secondary) network interface socket.
6. (Optional) Use Cat 5e cable to connect the KVM Over the NET™ switch's
PON port to an SA0142 Adapter. Connect the Adapter to the PON IN port
of a Power Over the Net™ unit.
Note: 1. For PN5/7, go to Device Management/OOBC/Console Port
Settings of GUI, and select the Baud Rate of 38400 bps.
2. Make sure the CC Management function is disabled for both the
KN and PN.
3. The PON unit shown in the example is the PN0108.
See Supported Power Over the Net™ Units, page 278, for a list of
suitable units.
7. (Optional) Use Cat 5e cable to connect the KVM Over the NET™ switch's
Modem port to an SA0142 Adapter. Connect the Adapter's serial
connector to the modem's DB-9 port.
8. Ground the switch using proper grounding wire to connect the switch's
grounding terminal to a suitable grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from surges or static electricity.
9. Plug the power cord(s) supplied with your package into the switch's power
socket, and then into an AC power source.
For the KN2124v, KN2140v, KN4124v, KN4140v, KN2116v, KN2132v,
KN4116v, and KN4132v when using a single power socket, be sure to turn
24