ATEN KN2124v User Manual page 180

KVM Over the NET™ User Manual
6. On the RADIUS server, Users can be authenticated with any of the
following methods:
Set the entry for the user as su/xxxx
Where xxxx represents the Username given to the user when the
account was created on the KVM Over the NET™ switch.
Use the same Username on both the RADIUS server and the
KVM Over the NET™ switch.
Use the same Group name on both the RADIUS server and the
KVM Over the NET™ switch.
Use the same Username/Group name on both the RADIUS server
and the KVM Over the NET™ switch.
In each case, the user's access rights are the ones assigned that were
assigned when the User of Group was created on the KVM Over the
NET™ switch. (See Adding Users, page 135.)
LDAP / LDAPS Authentication and Authorization Settings
To allow authentication and authorization for the KVM Over the NET™
switch via LDAP / LDAPS, refer to the information in the table, below:
Item
Enable
Type
LDAP Server IP
and Port
Admin DN
Admin Name
Password
Search DN
Timeout
164
Put a check in the Enable checkbox to allow LDAP / LDAPS
authentication and authorization.
Click a radio button to specify whether to use LDAP or LDAPS.
Fill in the IP address and port number for the LDAP or LDAPS
server.
You can use the IPv4 address, the IPv6 address or the
domain name in the LDAP Server field.
For LDAP, the default port number is 389; for LDAPS, the
default port number is 636.
Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kn4132,dc=aten,dc=com
Key in the LDAP administrator's username.
Key in the LDAP administrator's password.
Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Set the time in seconds that the KVM Over the NET™ switch
waits for an LDAP or LDAPS server reply before it times out.
Action