Accessories - Bosch 5312 Operating/Safety Instructions Manual

Troubleshooting Guide - General
PROBLEM CAUSE CORRECTIVE ACTION
Blade does not completely cut 1. Depth stop screw adjusted See Depth Stop Adjustment
workpiece, for groove cutting, in the Adjustment section.
Head assembly does not slide 1. Slide rail lock knob tight- Loosen slide rail lock knob.
freely when attempting a slide ened.
cut.
Head assembly slides forward 2. Slide rail lock knob not tight- Push head assembly corn-
and back when making a chop ened. pletely against stop. Tighten
cut. slide rail lock knob.
1.
Bevel setting does not hold
position.
Bevel lock lever assembly
needs to be tightened.
Tighten bevel lock lever as
shown on page 13.
DAF220K MiterFinder
TM
DigitalAnglefinder/Com-
pound Cut Calculator/Protractor/Level - Gives
you the information needed to position cuts so that
they fit together precisely even if the room is out of
square.
MS1221 Horizontal Quick Clamp Crown Stop
Bracket - Clamps workpiece against fence. Can
also be used as a crown molding stop. Mounts to
left or right side of the table.
MS1222 Extra-Long Base Rod Kit - Consists of
replacement steel rods that extend the total width of
base to 5 ft. (60").
MS1223 Length Stop Kit,
MS1224 Replacement Kerr inserts
MS1225 Replacement Dust Bag
MS1226 Replacement (Vertical) Quick Clamp
T3B TracRac
TM
Portable Stand with Wheels
T4B Gravity-Rise Wheeled Miter Saw Stand
-37-