Blade Square To Fence; Miter Scale Indicator Adjustment - Bosch 5312 Operating/Safety Instructions Manual

Adjustments
Blade Square to Fence
1. Make sure head assembly is pushed forward
near the center of the table and slide rail lock a.
knob is tightened, b.
2. Lower the head assembly, pull the lock pin out
and rotate it 90 °, rotate to lock the head assembly c.
in the down position. Make sure table is in 0°
detent and tighten miter lock knob. Place a com-
bination square against the fence and next to the
blade as illustrated. Locate the square properly d.
so it does not contact the tooth of saw blade.The
saw blade should contact the full length of the e.
square (Figure 9). f.
3. If blade does not contact the square, follow the
fence alignment procedure.
Fence alignment
Remove sliding fence extensions.
The head assembly should remain in lowered po-
sition.
Use multi purpose tool (supplied with model 5412
only) or use a 7/16" socket and loosen four (4) hex
bolts behind fence (Figure 10).
Adjust fence until blade and the fence has full
contact with the square.
Tighten hex bolts.
Re-attach sliding fence.
Hex Bolts
Fence
Blade
Combination Square
Figure 9. Blade Square to Fence Figure 10. Fence Adjustment
Miter Scale
indicator Adjustment
1. Rotate table to 0° position and lock in place.
2. Raise the head assembly to the full-up position.
3. Loosen the Phillips screw that holds the indica-
tor in place (Figure 11).
4. Position the indicator to align with the 0° miter
mark. Tighten the screw.
-15-
indicator
ustment
Screw
0 ° Mark
Miter Scale
Indicator
Figure 11. Miter Scale Adjustment