Table of Contents
Advertisement
Installation
Instructions
[STEP 15 LAYOUT DECORATIVE GRILLE
PANEL - FLUSH INSTALLATION
ONLY
Grille area will also have decorative
wood panel
attached
to installed
steel bracket.
Pilot holes are
necessary
to prevent
splitting
and cracking
of wood
panel.
1, Cut wooden
grille panel to specified
dimensions
as
noted on page 11,
2, Lay the grille panel face down on a non-scratch
surface,
3, Mark a vertical
centerline
on the back side of the grille
panel,
4, Lay supplied TEMPLATE to the back of the grille
panel with the lettering
face up, Align the top, side,
and centerline
of the template
with the top side and
centerline
of the door, Tape the template
in place
using masking tape,
5, Using a 1/8" wood drill bit, drill pilot holes into the grille
panel 1/4" deep,
6, Remove tape and discard template,
STEP 16] INSTALL GRILLE PANEL - FLUSH
INSTALLATION ONLY
1, Pull grille panel bracket
in an outward
motion allowing
it to swing out and up to the fully open position,
2, Lay the grille panel on top of the grille panel bracket
and align the pilot holes with the bracket holes from the
underside,
3, Fasten the grille panel to the grille panel bracket
using
provided screws in bracket hardware
kit,
23
Hide quick links:
Advertisement
Table of Contents
