Side Panels - GE ZISS480DRHSS Installation Instructions Manual

Installation Instruction
SIDE PANELS
Side panels must be used
whenever the sides of the
refrigerator will be exposed.
The 1/4" side panels will
slip into the side case trim.
Secure the panels to the
refrigerator with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
, Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
_84"
]_3" tO 4"
2-9/16"
Depending on installation height,
SIDE CLEATS
(Flush Installation Only)
Wood cleats are required to be installed vertically
down both sides of the cabinet opening to provide
depth stop for the refrigerator when installed into the
opening.
The front of the cleat should be installed 5-1/4" from
the front of the cabinet opening.
Finished
CJeat
3/4" PaneL_
-- Case Trim
TOOLS AND MATERIALS REQUIRED
, Tinsnips to cut banding
Stepladder
1" Bit extension
, Tape measure
, Gloves
, 1/4" Drywall screws
, 5-Gal. Bucket with cover
,6" Spirit level
, Appliance hand truck
, Tubing cutter
, 7/16" open-end wrench
, #2 Phillips screwdriver
, Drill and appropriate bits
,5/16". 7/16" socket
, Safety glasses
, 1-1/8" open end wrench
, Pliers
, 1/4". 5/16" Combo Rachet
,35" long 2x4 for Anti-Tip support
,1/4" copper water line tubing or GE SmartConnect TM
Refrigerator Tubing kits
, Water shut-off valve
, Custom panels for doors and grille panel
, Screws to secure refrigerator to cabinetry
, Stick-on hook and loop fastener strips for
1/4" side panels
HARDWARE SUPPLIED
, Water filter bypass plug
, Toekick
, 1/4" nut and ferrule
, Dispenser trim for overlay panels (for use with
Custom Panel models),
, Flush inset panel bracket kit
, Case trim package
13