Test Print - Fujitsu Fi-718PR Operator's Manual

7. Place the print cartridge into the holder as shown
below with its tab pointing to the right.
ATTENTION
Be careful not to let the print cartridge touch or catch onto
the print circuit film.
8. Lower the locking lever of the print cartridge
holder until it locks in place.
9. Position the print cartridge holder along where the
document will pass through.
10. Close the print cartridge cover.

2.3. Test Print

After installing the print cartridge, check if the printing
operation can be done.
HINT
For details about the operator panel, refer to
"fi-7160/fi-7260/fi-7180/fi-7280 Image Scanner Operator's Guide".
1. Press the [Power] button on the operator panel on
the scanner.
The [Ready] screen is shown on the LCD.
2. Load a blank document in the ADF paper chute
(feeder).
HINT
● Use an A4 or Letter size blank sheet. If the paper size is
smaller than A4 or Letter, printing may not complete
successfully.
● Confirm that the print cartridge is positioned within the
document width.
3. Press the [Menu] button.
The [Settings Menu] screen is shown on the LCD.
fi-718PR Imprinter Operator's Guide | 5