Removing laundry/switching the
appliance off
Open the front door of the washer and remove the
1.
laundry.
Turn the cycle selector to the Off position. Appliance is
2.
switched off.
Turn off the water tap.
3.
NOTICES
Do not leave any laundry in the drum. It can shrink or
▯
be discolored by the next laundry.
Signal
You can change the following settings:
volume for button signals
▯
volume for indicator signals
▯
To change these settings always activate adjustment
mode first.
Activate adjustment mode
Select Cotton Normal on Position 1.
1.
The appliance is on.
Hold down Start Pause and turn the Program Selector
2.
to the right (Position 2). Release Start Pause button.
Adjustment mode is now activated and the default
volume for indicator signals appears in the display.
Remove any remaining items from the drum and
▯
rubber gasket.
Leave the front door and detergent drawer open so
▯
that any remaining water can dry.
Always wait for the end of the cycle; otherwise the
▯
appliance may still be locked. If locked, switch the
appliance on and wait until it unlocks.
If at the end of the cycle the display is not lit up, the
▯
energy saving mode is active. To see display, press
any button.
Changing the volume
You can set the volume by touching the Finish in button
with the program selector in one of the following
positions:
Position 2: for indicator volume
▯
Position 3: for button signals volume
▯
Quit adjustment mode
Turn the Cycle Selector to Off position. The settings were
saved.
0 = off, 1 = soft,
2 = mid, 3 = loud,
4 = very loud
23