Cycle End With Rinse Stop; Cycle End; Removing Laundry/Switching The Appliance Off - Bosch WAP24200TC Use And Care Manual

Cycle end with rinse stop

Appears in the display field – – – and the indicator lamp
on the Start/Pause button blinks.
In order to exit the cycle, set the cycle selector to Spin/
Drain or select a spin speed range, then press the Start/
Pause button.

Cycle end

End appears in the display field and the Start/Pause
button indicator lamp is off.
If the cycle status sequence Wash is also flashing in the
display field, the washer has detected too much foam
during the washing cycle and it has then automatically
switched on a rinse to remove the foam.
NOTICE: Use less detergent the next time you run the
washer with the same load.
Removing laundry/switching the
appliance off
Open the front door of the washer and remove the
1.
laundry.
Turn the cycle selector to the Off position. Appliance is
2.
switched off.
Turn off the water tap.
3.
NOTICES
Do not leave any laundry in the drum. It can shrink or
▯
be discolored by the next laundry.
Remove any remaining items from the drum and
▯
rubber gasket.
Leave the front door and detergent drawer open so
▯
that any remaining water can dry up.
Always wait for the end of the cycle; otherwise the
▯
appliance may still be locked. If locked, switch the
appliance on and wait until it unlocks.
If at the end of the cycle the display is not lit up, the
▯
energy saving mode is active. To see display, press
any button.
26