Advertisement
Setting Oven
Controls
Setting Self Clean
The Self Clean
key controls the self clean feature.
If you are
planning
to use the oven directly
after a self clean cycle
remember
to allow
time for the oven to cool down and the oven
door to unlock.
This normally
takes about
one hour. So a 3 hour
self clean cycle will actually
take about
4 hours to complete.
It is recommend
to use a 2 hour self clean cycle for light soils, a
3 hour cycle
for average
soils, and a 4 hour cycle for heavier
soils.
To avoid
possible
burns use care when opening
the oven door after the self clean cycle,
stand to the side of the
oven when opening
the door to allow
hot air or steam to escape.
When
the oven is set for a self clean, do not force
the oven door
open. This can damage
the automatic
door locking
system. Use
caution
and avoid
possible
burns when opening
the door after
the self cleaning
cycle has completed.
The oven may still be
very hot.
To start an immediate
self cleaning
cycle or to set a delay start
time of 4:30
and shut-off
automatically:
1.
Be sure clock
is set for correct
time of day and door
is
closed.
2.
Press Upper
or Lower Oven.
3.
Press Self Clean.
CIn will flash and 3:00
HR will show in the
display.
Once in operation,
the oven will automatically
clean for a 3 hour period
(default
clean cycle).
Note:
If a 2 or 4 hour clean time is desired,
press 2 0 0 for 2
hour or 4 0 0 for a 4 hour clean time.
Figure 38:
Display showing the 3 hour self clean setting
4.
Press _.
The DOOR
LOCKED
icon will flash; CLEAN
icon
and the letters Ckn will remain
in the display.
5.
As soon as the control
is set, the motor driven
oven door
lock will begin to close automatically.
Once the door
has
been locked
the DOOR
LOCKED
indicator
light will stop
flashing
and remain
on. Also, the oven icon will appear
in
the display.
Note: Allow
15 seconds for the oven door
to lock.
If a delay Self Clean
is desired, finish steps 6-9.
6.
Press Delay Start.
Figure 39:
Oven before setting delayed
self clean cycle
Z
Enter the start time numbers
4 3 0 and press s_.
CLEAN,
DELAY, LOCK, and DOOR
will be displayed.
Figure 40:
Control
setting to delay self clean until 4:30
8.
The control
will start the self cleaning
at the set delay
start
time.
Figure 41: Display showing a delayed
self clean set
When
the self clean cycle ends:
1.
HOT will appear
in the display.
The time of day, the DOOR
LOCKED
and CLEAN
icon will remain
in the display.
2.
Once the oven has cooled
down
for approximately
one
hour, and the DOOR
LOCKED
icon is no longer
displayed,
the oven door can then be opened.
Stopping or Interrupting
Self Clean
If it becomes
necessary
to stop or interrupt
a self clean cycle
due to excessive
smoke or fire in the oven:
1.
Press @
"
2.
The oven door can only be opened
after
the oven has
cooled
down for approximately
one hour and the DOOR
LOCKED
icon is no longer
displayed.
Note:
If your clock
is set for normal
12 hour display
mode
the
delayed
self clean cycle can never
be set to start more than 12
hours in advance.
To set for delayed
self clean cycle 12 to 24
hours in advance,
set the control
for the 24 hour time of day
display
mode.
27
Advertisement
