Waste Disposal; Motor Oil Disposal; Battery Disposal; Trouble Shooting - Exmark Laser Z XS Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

5. WASTE DISPOSAL

5.1 MOTOR OIL DISPOSAL

Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at
a certified recycling center or according to your state and local regulations.

5.2 BATTERY DISPOSAL

Federal law states that batteries should not be placed in the garbage. Management and
disposal practices must be within relevant federal, state, or local laws.
If a battery is being replaced or if the unit containing the battery is no longer operating and
is being scrapped, take the battery to a local certified recycling center. If no local
recycling is available return the battery to any certified battery reseller.

6. TROUBLE SHOOTING

6.1 MOWER PULLS LEFT OR RIGHT (W/LEVERS FULLY FORWARD).
6.2 MOWER CUTS UNEVENLY.
6.3 ENGINE WILL NOT START.
POTENTIAL HAZARD
♦ Battery electrolyte contains sulfuric acid, which is
poisonous and can cause severe burns
WHAT CAN HAPPEN
♦ Swallowing electrolyte can be fatal or if it touches skin
can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Wear safety glasses to shield eyes, and rubber gloves
to protect skin and clothing when handling electrolyte.
♦ Do not swallow electrolyte.
a) Check air pressure in the drive tires; 10 psi.
Semi-pneumatic casters tires do not require inflation.
b) Refer to Tracking Adjustment Section 4.1.3.
c) Check reverse indicator and motion control linkage adjustment. See
Section 4.2.12 and 4.2.13.
a) Check air pressure in the drive tires; 10 psi.
Semi-pneumatic casters tires do not require inflation.
A higher tire pressure may provide a more uniform cutting height on rough
terrain. A lower tire pressure provides more flotation.
b) Check deck support chains.
c) Check deck leveling (See Adjustments Section 4.2.2.)
Note: The front of the mower deck will be approximately 1/4" lower than the
back of the mower deck. This is the "rake" of the deck.
d) Check blades tip to tip for straightness (they should be within 3/16"
(approximately one blade width) from being in line.)
a) Make sure the battery has a full charge. See Section 4.1.2 for charging
instructions.
b) Be sure the throttle control is midway between the "SLOW" and "FAST"
positions.
www.mymowerparts.com
DANGER
- 39 -